PREREQUISITES:

1. Backup your data:

   • Before you start, make sure to backup all your important data as flashing firmware may erase everything on your device.

2. Charge your device:

   • Ensure that your Realme 3i has sufficient battery charge to prevent any interruptions during the flashing process.

3. Download necessary files:

   • Download the official firmware for your Realme 3i from the official Realme website or other trusted sources.

4. Install necessary tools:

   • Install necessary tools such as Realme Flash Tool and USB drivers on your computer.
     

      

Steps to Flash Realme C3i Firmware:

1. 1. 1. Unlock Bootloader (if required):

         • Some devices may require an unlocked bootloader to flash firmware. Follow Realme’s official instructions for unlocking the bootloader if needed.

      2. Install USB Drivers:

         • Ensure that you have the correct USB drivers installed on your computer. These drivers can usually be obtained from the Realme website.

      3. Download Realme Flash Tool:

         • Download the Realme Flash Tool from the official Realme website or other trusted sources.

      4. Extract Firmware Package:

         • Extract the downloaded firmware package to a location on your computer.

      5. Open Realme Flash Tool:

         • Open the Realme Flash Tool on your computer.

      6. Load Firmware:

         • In the Realme Flash Tool, click on “Browse” or a similar option to locate and load the firmware file you extracted earlier.

      7. Connect your Realme 3i:

         • Power off your device and connect it to your computer using a USB cable while holding down the required key combination (usually Volume Down + Power) to enter fastboot mode or recovery mode.

      8. Start Flashing:

         • Once your device is connected and detected by the Realme Flash Tool, click on the “Start” button to begin the flashing process.

      9. Wait for Completion:

         • Wait for the flashing process to complete. Do not disconnect your device during this time.

      10. Reboot:

          • After successful flashing, your device may automatically reboot. If not, you can manually reboot your device.

Remember that these instructions are based on general steps for flashing Realme MTK and Qualcomm devices. The exact steps might vary slightly based on the specific firmware and version you’re using. So we can’t take responsibility for these instructions. Always refer to the official documentation and resources for your device and tools.